View Cart Help Desk TellAFriend
Call Us: 1-469 955-1740
8am - 5pm CST Mon - Fri
Structured Wiring Design Manual
Solutions for wiring a home
Wiring an Office
Do it Yourself Resources
Structured Wiring by the Sq Ft
Cat5e and Cat6 Comparision
A/V Switching & Extension
Residential Composite Cable
Bulk Cat6 Cable
Bulk Cat5e Cable
RG6 Coaxial Cable
In-Wall Speaker Cable
Audio Video Cables
Tools & Testers
Paladin Structured Wiring Kit
Products by Manufacturer
Click to see Customer Ratings
Spaun HDTV ready DSS Satellite Multiswitch 5 input 12 output - 5x12 DISCONTINUEDSpaun DMS 51202 NF HDTV DSS Multiswitch is the latest Satellite distribution multiswitch from Spaun Germany. This multiswitch has a built-in amplifier is compatible with the twin dual-LNB DSS dish(Duo Sat). All four RG6 Coax cables from the Satellite dish are connected to the multiswitch input. The fifth input is for Antenna or Cable TV input.
Compatible with DirectTV and Dish Network Satellite Service
A single RG6 Coax cable run is needed to each DSS Receiver. Upto 12 DSS receivers can be connected to this multiswitch. To receive the Antenna / Cable TV a
diplexer is needed at each location.
HDTV Multiswitch Wiring Diagram
Duo-Sat Wiring Diagram
Dimensions in mm
(To convert to
inches, divide by 25.4)
- SAT-IF with
- DUO-SAT system
- IF Polarity
selection is controlled by remote voltage, <14.5vV,>16vH &
the 22kHz tone provided by the receiver
level for SAT 0...-10dB
- Return path
consumption 40 mA
consumption 26 Watts
HDTV Multiswitch Installation Notes
LNB Supply Mode
18V: All multiswitches in the USA should be set to 18V.
Connecting Satellite Signals to Multiswitch
SAT A (101): 1 coax to V/Low input, 1 coax to H/Low input.
SAT B (119): 1 coax to V/High input, 1 coax to H/High input.
Synchronous Level Adjuster (Small orange dials)
To adjust (decrease) different input levels by 0…-10dB if necessary.
Terrestrial input allows for either Off-air antenna or Cable to be passed through the multiswitch.
Protocol when using the DirecTV 5x4 integrated multiswitch with 3rd LNB
If using an elliptical dish with the 5x4 integrated multiswitch with a 3rd LNB for the 110 orbital slot:
You must use the integrated multiswitch in conjunction with a Spaun Duo-sat multiswitch or cascadable system and turn the LNB dial to 22 kHz.
Bring the 4 coax cables directly from integrated switch and into Spaun multiswitch just as if they were coming directly from the LNB's.
Do not mount the multiswitch in damp conditions. Protect from weather and allow adequate ventilation
Availability : DISCONTINUED
|Wiring your home or office? Need input from friends & colleagues? Go social by clicking on your favorite social networking tool below.