Design is for 2 Storey single family residence 3500 Sq. Ft.
Please read solution specification below and then look at solution components (links to products) at the bottom to get a complete view of
your solution. Please send us email with questions/comments you might have.
To place the order, Keep this page open and click on each item and add it to the shopping cart on the other window that pop's up. Make the quantity and color choices recommended. Once an item is added come back to this page and click on next item.
Keep adding items to cart and go to checkout and fillout first page to get a price quote including shipping charges.
Solution Specification:
Four types of outlets for audio video data telephone (whole house described seperately)
VDT : Video, Data, Telephone, powered by composite cable DT : Data + telephone powered by cat5e cables HT : Home theater 5 pairs of binding post modules for audio input. Located behind entertainment/TV unit. (Other end terminates directly on to the speakers. VC : video camera, run one RG6 and 1 cat5e to each of the interior/exterior camera location. Three technologies available, CCTV($), IP camera($$), IP camera with Power over ethernet($$$) wire for both.
CCTV uses 1 RG6 for video and cat5e for 12V DC
IP camera uses cat5e for signal and control and have a 110 V AC close by for power.
IP camera with power over ethernet handles signal/control and power all from one cat5e but is very expensive now.
When pre-wiring for video camera leave ample extra length on camera end and cover gang box with wallplate.
Home Orientation
For the sake of this design I have considered
top of page to be North, Bottom is South, Right edge
of page is East and Left edge of page is West.
Great room
2 VDT One on west wall and another on the north east corner for easy viewing from kitchen/dining.
1 HT wiring in the great room. wires start at one of the two VDT locations of your choice and terminate on wall or ceiling depending on your speaker type(front floor standing/satellite, rear wall mounted(flush/surface) or ceiling mounted(surface only)
Kitchen and Dining
1 VDT on north kitchen wall under cabinet/on splash-board to allow tel, data and under cabinet TV.
1 DT on splash board near fridge
1 VDT in the south-east corner of dining
Office/Exercise
1 VDT on north west corner at ceiling height for
watching from treadmil/office desk. you can optionally
peel off the two cat5e cables and provide video at ceiling height and data/telephone
at 18 inch height for office use.
2 DT one on south wall center and another on north-east corner.
Guest Suite
1 VDT on East wall (if low seat/desk permits or install on north wall
1 DT on east wall at nightstand north of the bed
Bedroom #4 (2nd floor north)
1 VDT on east wall
1 DT on west wall at nightstand south of the bed
Bedroom #3 (2nd floor West)
1 VDT on North wall
1 DT on South wall at nightstand east of the bed
Master Bedroom
1 VDT on South wall east corner
1 DT, on one side of the bed
Loft
2 VDT on your choice of wall to cover for the potential TV locations.
Whole House Audio
An 8-zone A-bus whole house audio system with
built in IR repeater system.
Building blocks are:
2 x 4 zone distribution module
installed at the wall where the main entertainment unit will
reside (great room?)
2 x 24 V power supply
8 x amplified keypads
Wiring is 1 cat5e from distribution module to
structured wiring panel and cat5e from hub to each
amplified keypad. Speaker wire 14/2 from
keypad to the ceiling/wall speakers.
8 pairs of ceiling or wall speakers.
Looks like we have 3 downstairs zones (covered patio, office
and guest suite) and 5 upstairs zones (sun deck(outdoor wall mount speakers, loft, bedroom #3, bedroom#4, master bedroom)
(we dont sell Russound items and cannot quote you on it.
cable estimates however are included.
IP camera/CCTV camera
run one cat5e and one rg6 cable to each potential
camera location. (eg porch, and sun deck for outdoors
and the 2 kids bedrooms) For indoors use IP camera and
install camera diagonally opposite from door at ceiling
height to cover entire room, also provide 110V AC to power
IP camera For outdoors use weatherproof bullet camera
and CCTV technology.
(I have calculated cable and data connections you need
in the structured wiring panel, we
only sell IP cameras and dont have CCTV cameras)
Te
Total outlets(wallplates) of each type
VDT=11
DT=7
VC=8
HT=1
Total outlets by service type
Video 11
Data 11 + 7 + 8 (for Ip cameras) = 25
Telephone 11 + 7= 18
Surround sound 5.1/Home Theater 1
